Battery-controlled embellishments on a boat frequently work on some different option from a 12-volt power source. For instance, trolling engines frequently require either 24 or 36 volts. Most promptly accessible batteries do not as a rule come in those voltages; so you can interface at least two in a series to twofold or triple your voltage while keeping up with a similar limit rating Amp Hours. A significant thought during this cycle is battery science; do not utilize two unique sciences while interfacing in series or equal. Ensure the voltages are something very similar, however more significantly the charge rates and limits are something very similar to assist with delaying battery life.
For one thing, ensure what you have, you would rather not feed 36 volts to a 12 volt trolling engine. Whenever you have established that you without a doubt have a 36 volt trolling engine you then, at that point, need to ensure you have space in the 12V lithium battery compartment for three standard size marine batteries. Additionally, it is insightful to go the additional yards and ensure you have either boxes or mounting sections for every one of the three batteries. You do not need these power sources flipping all around the frame while you are hitting waves. You will initially have to make two jumper wires, around 2 feet in length. You can get the essential parts at any auto supply store or boat vendor. When you have these finished you are prepared to make the series association. To make it somewhat easier and keep it straight, give the batteries a number assignment, for example, 1, 2, and 3. It does not make any difference which number is relegated to which battery as this is done with the goal that the other guidelines are straightforward.
Organize the power units in the battery compartment of your boat with the goal that their contrary terminals are close to each other. The adverse terminal of 1 ought to be close to the positive terminal of 2, and the adverse terminal of the 2 ought to be close to the positive terminal of 3. Associate your most memorable jumper wire between the adverse terminal of the principal battery and the positive terminal of the subsequent battery. Associate your subsequent jumper wire between the adverse terminal of the subsequent battery and the positive terminal of the third battery. Attach the positive lead from the trolling engine to the positive terminal on the primary battery. Attach the adverse lead from the trolling engine to the adverse terminal on the third battery. Your series is currently finished and you have an entire 36 volts of capacity to your trolling engine. For a 24 volt framework, you basically leave out the third battery and interface the adverse lead from the trolling engine to the adverse terminal of the subsequent battery.
By 
